• Send Message Command Prompt
• Maestro Send At Commands By Messages

Send message through command prompt with IP Solved/Closed Cornwall - Updated on Dec 16, 2018 at 09:37 AM - Latest reply: v - Mar 16, 2018 at 05:51 PM. Network Ask a question Report. Hello, I'm trying to find out how to send text based or another type of message though command prompt directly to another person's computer just knowing their IP. Maestro m100 series smartpack user manual version 5 for application version 2.2.3 on m1002g, m1003g, m1003g485, m100cdmaplus, m100cdma485 www.maestro-wireless.com email: support@maestro-wireless. The NMEA Reference Manual provides details of NMEA messages developed and defined by SiRF. It does not provide information about the complete NMEA-0183. 150 OK to send message 151 GPS Data and Extended Ephemeris Mask 152 Extended Ephemeris Integrity 154 Extended Ephemeris ACK Table 1-2 Supported NMEA Output Messages.

Hello,

I've two Xbee modules from the series 1 and I want to send AT commands from one to another. I've one of them assembled in an Arduino UNO and the other one connected to the PC through Xbee Explorer USB device. I'm using the X-CTU software (console mode) and the Serial Monitor from Arduino IDE.

I've the following code:

SoftwareSerial mySerial(3, 2); // RX, TX

void setup() {
// Open serial communications and wait for port to open:
Serial.begin(9600);
while (!Serial) {
; // wait for serial port to connect. Needed for native USB port only
}

Serial.println('Goodnight moon!');

Send Message Command Prompt

Maestro Send At Commands By Messages

// set the data rate for the SoftwareSerial port
mySerial.begin(9600);
mySerial.println('Hello, world?')
} Download brian lara cricket 2007 pc latest version.

void loop() { // run over and over
if (mySerial.available()) {
Serial.write(mySerial.read());
}
if (Serial.available()) {
mySerial.write(Serial.read());
}
}

With this code I can exchange messages between the two devices. For example, If I send '+++' from the Serial Monitor (Arduino) I get 'OK' as response, but if i send an AT command like 'ATDL' I get nothing. I've tried all the diferent options in Serial Monitor like New Line, Carriage Return, Both.. and nothing happens.

Anyone knows what am I missing?

Thank you!